Proc:Trap

Overview

The trap procedure allows builders to combine a single trigger with multiple effects. Some effects maybe be harmful, while others helpful. The settings for the trap are assigned via the setproc command.

Key	Default	Description
TRAP_INITIALCHARGES	0	The number of charges the trap has per zone reset. If this value is negative, the trap has infinite charges.

Triggers

The trap may only have one trigger which is set in the TRIGGER_TYPE key value.

Value	Description
Generic	Activates when players enter the room or perform a command.
MobileDeath	Activates when a particular mobile is killed.
Password	Activates when a player says a particular word.
PressurePlate	Activates when the sum of the weights of all players/mobiles in the room reach a particular threshhold.

Trigger Settings

Global settings that may be applied to the trigger.

Key	Default	Description
TRIGGER_CHANCE	100	The percentage chance that the trigger will activate.
TRIGGER_MINPRIMELEVEL	0	The minimum prime level required to activate the trigger.
TRIGGER_MAXPRIMELEVEL	40	The maximum prime level allowed to activate the trigger.
TRIGGER_ACTIVATIONDRELAY	0	Approximate number of seconds to delay the effects after the trigger is activated. Note that setting this value allows for the player activating the trigger to escape - which means they may not be present for any of the effects.
TRIGGER_SPELLEXEMPTIONLIST	No exemptions	A colon (:) separated list of spells/skills that make the player exempt from activating the trigger.
TRIGGER_INCLUDEMOBILES	0 (FALSE)	Indicates whether or not independant mobiles should be able to activate the trigger. If this value is left at zero, wandering mobiles will not activate the trap nor count toward cumulative activations such as pressure plate weights. Mobile followers (supplications, summoned undead, etc) are always able to activate the trigger unless their master's prime level falls outside the trigger's boundaries or unless the follower is affected by a spell in the spell exemption list.
TRIGGER_MESSAGE_ACTOR	No message	Message sent to the player who activates the trigger.
TRIGGER_MESSAGE_ROOM	No message	Message sent to the room when the trigger is activated.

MobileDeath

The mobiledeath trigger will activate if a particular mobile is killed in this room. It ignores most of the trigger settings including TRIGGER_MINPRIMELEVEL, TRIGGER_MAXPRIMTELEVEL, and TRIGGER_SPELLEXEMPTIONLIST.

Key	Default	Description
MOBILEDEATH_VNUM	-1	Vnum of the mobile to react to.

Password

The password trigger will activate if a player says a particular word.

Key	Default	Description
PASSWORD_VALUE	(none)	The password.

PressurePlate

The pressureplate trigger activates when the weight of the applicable players and mobiles crosses a threshhold.

Key	Default	Description
PRESSUREPLATE_WEIGHT	0	The amount of weight needed to activate the trigger.

Effects

Note that if a the trap has a non-zero activation time and is set to only affect the person triggering the trap, the person may be gone and the trap may affect noone.

Key	Default	Description
EFFECTS_SPELLEXEMPTIONLIST	Empty	Colon (:) separated list of spells that exempt the player/mobile from being affected by any of the trap's effects.
EFFECTS_LIST	Empty	Colon (:) separated list of effects enabled for this trap. Effects are activated in the order they appear.

Supported effects:

Key	Description
Damage	Does damage to one player/mobile or the room.
DoorState	Changes the state of upto 100 doors.
Lag	Lags the players or all players in the room.
Portal	Opens a portal between two rooms.
SpawnMobiles	Spawns one or more mobiles.
SpawnObjects	Spawns one or more objects.
Teleport	Teleports players/mobiles from one room to another.
ZoneAlarm	Either sets or clears the zone alarm.

Damage

The damage effect does damage to the player/mobile activating the trigger or the entire room.

Key	Default	Description
DAMAGE_DICE	1	The number of dice used when calculating damage.
DAMAGE_DIESIZE	1	The size of the die or dice used when calculating damage.
DAMAGE_ADDITIONAL	0	An amount added (or subtracted) to the damage total.
DAMAGE_TYPE	Undefined	Type of damage done.
DAMAGE_AFFECTROOM	0	Boolean value determining whether everyone in the room takes damage.
DAMAGE_INCLUDEMOBILES	0	Boolean value determining whether unrelated mobiles take damage from the trap. If this value is left at zero, wandering mobiles will not take damage from the trap. Mobile followers (supplications, summoned undead, etc) will always take damage unless their master's prime level falls outside the trigger's boundaries or unless the follower is affected by a spell in the spell exemption list.
DAMAGE_ALLOWDEATH	0	Boolean value determining whether players/mobiles can be killed by the trap. By default the player/mobile will be taken down to 0 hit points and stunned. It is strongly recommended that this only be changed in the most harshest of areas.
DAMAGE_MESSAGE_ACTOR	No message	Message shown to the player receiving damage.
DAMAGE_MESSAGE_ROOM	No message	Message shown to the room for the player receiving damage.

DoorState

The doorstate effect can change the states of up to 100 doors. The effect automatically sets both sides of the door to match. In the table below, the key name uses #### to represent the virtual number of the room containing the door and XXXX to represent the direction of the door in that room.

Key	Default	Description
DOORSTATE_####_XXXX_STATE	none	Sets the door's state to either "OPEN", "CLOSED", or "LOCKED".
DOORSTATE_####_XXXX_MESSAGE_UNLOCKING	No message	Message sent to the room if the effect causes the door to unlock.
DOORSTATE_####_XXXX_MESSAGE_OPENING	No message	Message sent to the room if the effect causes the door to open.
DOORSTATE_####_XXXX_MESSAGE_CLOSING	No message	Message sent to the room if the effect causes the door to close.
DOORSTATE_####_XXXX_MESSAGE_LOCKING	No message	Message sent to the room if the effect causes the door to lock.

Lag

The lag effect adds lag to the affected players.

Key	Default	Description
LAG_SECONDS	0	The number of seconds to lag the player.
LAG_AFFECTROOM	0	Boolean value that determines if the entire room is affected.
LAG_MESSAGE_ACTOR	No message	Message sent to the player when they are lagged.
LAG_MESSAGE_ROOM	No message	Message sent to the room for each player that is lagged.

Portal

The portal effect creates a portal from one room to another.

Key	Default	Description
PORTAL_SOURCE	-1	Source room to create the portal. If not specified or set to -1, the proc uses the current room as the source.
PORTAL_DESTINATION	-1	Destination room used to create the portal. If not specified or set to -1, the proc will not run.
PORTAL_DURATION	3 hours	Number of hours before the portal will disappear.
PORTAL_TWOWAY	1	Boolean value indicating whether or not the portal should be two-way.

SpawnMobiles

The spawnmobiles effect will create mobiles in one or more rooms.

Key	Default	Description
SPAWNMOBILE_LIST	Empty	Colon (:) separated list of mobile vnums to create. The same vnum may be listed more than once, but will use the same settings for all mobiles with the same vnum.
SPAWNMOBILE_####_DESTINATION	-1	Destination room to spawn the mobiles. If unspecified or set to -1, the current room is used.
SPAWNMOBILE_####_QUANTITY	1	Number of mobiles to spawn with this vnum. The current maximum value is 10.
SPAWNMOBILE_####_MESSAGE_ROOM	No message	Message sent to the room for each mobile spawned.

SpawnObjects

The spawnobjects effect will create mobiles in one or more rooms.

Key	Default	Description
SPAWNOBJECT_LIST	Empty	Colon (:) separated list of object vnums to create. The same vnum may be listed more than once, but will use the same settings for all objects with the same vnum.
SPAWNOBJECT_####_DESTINATION	-1	Destination room to spawn the objects. If unspecified or set to -1, the current room is used.
SPAWNOBJECT_####_QUANTITY	1	Number of objects to spawn with this vnum. The current maximum value is 10.
SPAWNOBJECT_####_MESSAGE_ROOM	No message	Message sent to the room for each object spawned. This message does not support $ replacement.

Teleport

The teleport effect telports players and/or mobiles from one room to another.

Key	Default	Description
TELEPORT_SOURCE	-1	Source room to teleport from. If unspecified or set to -1 the proc uses the current room.
TELEPORT_DESTINATION	-1	Destination room to teleport to. If unspecified or set to -1 the proc uses the current room.
TELEPORT_AFFECTROOM	0	Boolean value indicating whether to teleport everyone in the source room.
TELEPORT_LOOKATDESTINATION	1	Boolean value indicating whether players should automatically look in the room once they reach their destination.
TELEPORT_MESSAGE_ACTOR	No message	Message sent to the player when they are teleported.
TELEPORT_MESSAGE_SOURCE_ROOM	No message	Message sent to the source room when the player teleports away.
TELEPORT_MESSAGE_DESTINATION_ROOM	No message	Message sent to the destination room when the player arrives.

ZoneAlarm

The zonealarm effect either sets or clears the current zone's alarm.

Key	Default	Description
ZONEALARM_STATE	1	Boolean value indicating whether the alarm should be set (1) or cleared (0).
ZONEALARM_ACTIVATE_MESSAGE_ROOM	No message	Message sent to the room when the alarm is activated.
ZONEALARM_DEACTIVATE_MESSAGE_ROOM	No message	Message sent to the room when the alarm is deactivated.